Kitchen Measurement and Appliance Checklist
Kitchen drawings depend on more than wall length. Appliances, plumbing, ventilation and door movements all affect the usable layout. Final measurements should be taken on site and checked against the actual selected products. A small dimensional mismatch can prevent a drawer from opening or leave an appliance without the access its manufacturer requires.
Plan this with Casalens
Measure the room and its obstacles
Record wall lengths, ceiling height, windows, sills, doors, columns and exposed services. Note skirting and surfaces that are not square or level. Check the finished floor level and any proposed changes to tiles or wall finishes. Identify service shafts and inspection points that must remain accessible. Measurements taken before demolition may need to be repeated after repairs or finishes change the usable dimensions.
Confirm appliance models
Collect manufacturer installation drawings for the hob, chimney, refrigerator, oven, dishwasher and other built-in equipment. Record required openings, ventilation and service access rather than relying only on the overall product size. Check door and drawer movement. A refrigerator may need clearance to remove internal bins; a dishwasher door can affect circulation. Do not manufacture the cabinet around an approximate appliance category when the final model is still undecided.
Coordinate services professionally
Mark water, waste, gas and electrical positions with the responsible qualified trades. Confirm accessible shut-offs and suitable connection locations. Avoid placing services where drawers or structural cabinet members will clash. Appliance installation requirements should guide the coordination. Any change to gas or electrical systems must be handled by competent authorised professionals where applicable. Keep service access in the drawing instead of hiding connections behind fixed panels.
Approve one coordinated drawing
Review cabinet elevations, appliance positions, countertop cut-outs and service points together. Assign responsibility for measurement at each supplier interface. Check who templates the countertop and when that happens. Record finish, handle and hardware selections. Before approval, walk through cooking, cleaning and storage movements on the plan. Retain the final drawing revision for installation and handover checks. Check that appliance delivery routes through the entrance, lift and kitchen door are practical before arranging delivery.
Questions homeowners ask
Can I use the builder’s plan for final fabrication?
Use it for planning, then verify actual site dimensions and conditions before fabrication.
What appliance details are essential?
Exact model, installation dimensions, ventilation clearances, connections and door movement.
Who should approve service changes?
The responsible qualified trade should assess and execute electrical, plumbing and gas changes as applicable.
YOUR HOME, YOUR PRIORITIES
Start with the space you have.
Share your floor plan, Bangalore location and the work you need. Confirm service availability, site requirements and the itemised scope before booking.
Discuss your projectExplore the indicative calculator →